Dimming light to 20% by setting level of
input power.
Self-diagnostic indication for
malfunctions - shows failure cause of lamp/ballast/connection, etc.
Ready to connect to central lighting control system.
the communication with the ballast is provided by a connection
interface using RS232 protocol, which allows power control and diagnostic
readout.
Manual operation:
Dimming level preset on ballast.
Dimming delay time can be performed by an
external command or internal timer.
Heat losses are 50% less than
electromagnetic
ballast. Efficiency
of 90% and more.
Increased light intensity.
Constant light intensity over time and
over variation of line voltage.
Up to 5% decrease after 10,000 hours (estimated).
Longer lamp life. No flickering.
Constant light at line nominal voltage
variation 185-250 volts.
Constant light at line voltage variation
185-250 volts at nominal voltage 220 volts.
Constant light at line voltage variation
85-135 volts at nominal voltage 110 volts.
Power factor cos ~
1.0.
Protected against short circuit of lamp
cables and inverse connection between line and lamp cables.
Smart ignition algorithm for quicker hot
restrike and prevention of striking burned-out or flickering lamps.
Can be installed up to 30 meters from lamp - no
special wires required.
Meets all applicable European and
American standards.
~
1.0.